Operation Manual

79
M
A
S
M
A
S
POST DIVE AFTER 10 MINUTES ON SURFACE
Once 10 minutes have elapsed, the Surface Interval time colon
will stop flashing indicating that the Dive and Transition Period
are completed, and a subsequent descent will be considered a
new dive.
You will then have full access to all NORM DC surface modes
(e.g., Plan, Fly, Sat, Log, Hist, Set, etc.).
• Press and release the S button momentarily (< 2 sec) to
access Plan Mode.
> Adjusted No Deco Limits will be displayed based on
residual nitrogen and accumulated oxygen calculated to be
remaining from the previous dives.
• While viewing the first Plan screen, press and release the A
button momentarily (< 2 sec) to access the Time to Fly
screen (Fig. 74), then press it again to access Dsat Time
screen (Fig. 75).
> The Desat counter provides calculated time for tissue
desaturation at sea level.
> If a Violation occurred during the dive, the Desat screen will
not be displayed.
Once 2 hours have elapsed after surfacing from a dive, only the
Fly and Sat screens will be displayed (alternating), counting
down to 0:00 (hr:min), then the unit will shut off.
Fig. 74 - TIME TO FLY
Fig. 75 - DSAT TIME