Needed For Models : 6736208 Adjustable Wrench Groove Joint Plier Teflon Tape Included Tangier Single Handle Tub/Shower Faucet
Shower Arm Flange Shower Arm Shower Head Knob Sleeve Protective Cover Spline 1 2 3 10 7 11 12 13 Spring Diverter Seat 14 15 O-ring 9 8 O-ring Sealing Washer 16 17 Diverter Core Diverter Spring 18 6 Washer 19 5 20 4 25 26 27 28 29 30 Valve Body 31 33 32 Cartridge Housing 34 Pressure Balance Cartridge Lock Nut Trim Cap 21 35 23 Handle 36 24 Set Screw 37 Screw 22 Sleeve 38 42 41 40 39 Adjuster Seat 22 O-ring Adjuster O-ring Spring 22 Stopper Sealing Washer Washe
1. Note the installation dimension between shower arm, handle and spout. 1/2-14NPT 3-5/8" (91mm) 6-1/4" (159mm) 6-11/16" (170mm) 7" (178mm) 8-13/16" ∅(223mm) Min 8 " -Max 12 " (203mm-305mm) Recommended 74” ( 1880mm) Minimum From Floor To Showerhead, Or Greater As Desired 1-1/2" -2-3/16" (38mm-56mm) 4-1/2-14NPT 6-5/16" (160mm) 1/2-14NPT 2. If this is not a thin wall mounting, the protective cover (#6) may be removed from the valve body (#16).
Installation Instructions 5. Turn on hot and cold water supply lines. Turn on the faucet and let the water run from the tub spout for one minute to flush the debris from the line. If there is a leak, refer to correct section and repeat step. 6. Before install, please slip flange (#1) onto the longer end of shower arm (#2). Wrap threads of the longer end of shower arm with teflon tape and install shower arm. Wrap threads of the shorter end of shower arm with teflon tape and install shower head (#3).
Installation Instructions 9. Install escutcheon plate (#35) and secure with screws (#41) and o-ring (#39). Make sure valve is in off position. 35 39 41 10. Assemble the handle (#21) on the escutcheon plate (#35), secure with the set screw (#22). Assemble the knob (#4) on the escutcheon plate (#35).
Lock nut (#19) has come loose or Tighten the lock nut (#19). Clean o-ring on cartridge (#18) is dirty or or replace o-ring on cartridge (#18). twisted. (#18) (#18) 8 (#18).