Needed Adjustable Wrench Groove Joint Plier Teflon Tape Included Power Drill For Models : 6736197 Forden Single Handle Shower Faucet With Slide Bar Shower Head
1 3 Valve Body Cartridge 2 4 7 End Cap Washer 5 6 Cartridge Housing Lock Nut Trim Cap 8 9 16 15 Protective Cover Screw 10 12 11 14 13 Sealing Washer 17 Stoper Spring 18 O-ring 20 Adjuster 21 O-ring 22 Adjuster Seat 19 Sealing Washer 27 Washer 23 Escutcheon Plate Handle Set Screw 28 26 25 24 21 29 31 30 32 33 34 22 Shower 23 Shower Hose 24 Shower Holder 25 Wall Supply 26 Slide Bar 27 Trim Cap 28 Base Support 29 Screw 30 Insert 31 Handle Button 32 Al
1. If this is not a thin wall mounting, the protective cover (#8) may be removed from the valve body (#3). Please Note: Be sure the valve body is secured to the support cross board for stability. 3 3 2. 3. Install the nipple to the stub out, using the proper length nipple so that the nipple extends 3/8” from the finished wall. In order to assure proper function, piping from the bottom portion of the valve to the water supply stub out must be 1/2" nominal copper pipe or 1/2" iron pipe.
Installation Instructions 6. Install escutcheon plate (#19) and secure with screws (#34) and o-ring (#33). Make sure valve is in off position. 19 33 34 19 7. Assemble the handle (#20) on the escutcheon plate (#19), secure with the set screw (#21). 20 21 8. Turn on the faucet and let the water run from the water supply stub out for one minute to flush out the debris from the line. 9. Install wall supply (#25). See diagram for visual. 25 10.
Installation Instructions 28 30 28 29 29 27 30 27 26 26 (656mm) (656mm) 23 A B Step 10 11. Install tub shower hose (#23). See diagram for visual. 12.
Leaks underneath handle. Water will not shut off completely. Water temprature can not be adjusted, or no hot or cold water. Lock nut (#6) has come loose or o-ring on cartridge (#4) is dirty or twisted. Rubber valve seat at the base of pressure balance cartridge (#4) is dirty or broken. Dirty cartridge (#4). Revised on 12/19/2018 Tighten the lock nut (#6). Clean or replace o-ring on cartridge (#4). Remove handle and pressure balance cartridge (#4) to check the rubber valve seat. Clean or replace it.
