Tools Needed For Models : 6736210, 6736211 Adjustable Wrench Groove Joint Puller Phillips Screwdriver « Silicone Sealant Teflon Tape 6736212 MARIANA Single Handle Bathroom Faucet Maintenance Your new faucet Is designed for years of trouble-free performance. Keep It looking new by cleaning It periodically with a soft, damp cloth. Av old abrasive cleaners, steel wool and harsh chemicals as these will dull the finish and void your warranty.
Parts Diagram / List 5 & No.
Preparation/Assembly 1. Shut off the water supplies before installation. Remove the current faucet. Clean and dry the surface the new faucet will be installed on. Note: This faucet flees 3 counter tops. and the rubber washer Note: Do not remove the customer service tag with the model number and phone number. This information will be needed when calling the customer service department. . Apply Teflon tape to the threads of the waterway (#8) (hot and cold water supply tubes) in a clockwise direction. .
Installation Instructions 5. Slip 2" coupling nuts onto the water supply tubes or use flexible stainless steel supply lines (recommended) both are sold separately. Use two wrenches (as shown) to keep from twisting the supply tube off of the faucet when tightening the nut. 6. Apply Teflon tape onto the threads of the faucet water shut offs in a clockwise direction. Tighten the water supply hoses onto the water supply shut offs.
Installation Instructions 11. From underneath the sink, slide the washer (#25) and wearing ring (#26) onto the stopper housing (#22 or #23), then screw on the lock nut (#27) hand tight. Do not over tighten. See the diagram for a visual. 12. Slide the nut (#30) over the outlet pipe (#29) and insert the O-ring (#28) onto the outlet pipe Screw the nut (#30) onto the stopper housing (#22 or #23) hand tight. Do not over tighten. Note: The outlet pipe (#29) connects to the p-trap drain.
Troubleshooting If you've followed the Instructions carefully and your faucet still does not work properly, take these corrective steps. Problem Cause Acton Turn off the water supplies. Remove the handle (#1) and trim cap If the lock nut [#5) is loose tighten it.