Tools Adjustable Wrench (2) 5, « Teflon Tape Groove Jo lint Puller « Phillips Screwdriver . Silicone Sealant For Models: 6736214, 6736215 6736216 & MARIANA Single Handle Bathroom Faucet Maintenance Your new faucet Is designed for years of trouble-free performance. Keep It looking new by cleaning It periodically with a soft, damp cloth. Av old abrasive cleaners, steel wool and harsh chemicals as these will dull the finish and void your warranty.
Parts Diagram / List Part Name % 1 Handle Button @_/4 2 | setscrew 3 Handle % 5 @ 4 Trim Cap 19 5 Lock Nut 20 6 | Cartridge 18 7 Aerator é \D 8 Body @\ 9 O-ring 14 10 | O-ring 1 Bolt 12 Tube -7 13 | Tube 8 15 :; Sam ut Socket Wrench 16 Deck Plate 17 | Gasket 18 | Nut 19 | Allen Wrench 20 | Aerator Wrench 21 Knob 22 Lift Rod 23 Pop Up Assembly 24 Stopper 25 | Threaded End 26 | Washer 27 | Washer & Lock Nut 28 Pop-up Body 29 Ball Rod 30 | Ball Nut 31 Spring Clip 32 | Sealer 33 Rod Strap Have a question? DON'T
Preparation/Assembly 1. 2.Note: For single hole Installation see step 3. Shut off the water supplies before Installation. Remove the current faucet. Clean and dry the surface the new faucet well be Installed on. Note: This faucet fits 3 counter tops. Deck Plate Installation: Verify the O-ring (#9) is in place. Attach the gasket (#17) to the deck plate ensuring the notches on the deck plate (#16) line up for proper Installation.
Installation Instructions 6. 10. 11. Slip 2" coupling nuts onto the water supply tubes or use flexible stainless steel supply lines (recommended) both are sold separately. Use two wrenches (as shown) to keep from twisting the supply tube off of the faucet when tightening the nut. Water Supply Hoses . Apply Teflon tape onto the threads of the faucet Water Supply Hoses water shut offs in a clockwise direction. Tighten the water supply hoses onto the water supply shut offs.
Installation Instructions 12.Remove the ball nut (#30) and the sealer 24—@ Insert the stopper (#24) into the pop-up body t Align the hole in the stopper (#24) with the guide rod opening. (See the diagram for a visual.) Slide the 29 30 sealer (#32) onto the ball rod then insert the 28— ball rod (#29) through the hole in the stopper Screw on the ball nut 13.
Troubleshooting If you've followed the Instructions carefully and your faucet still does not work properly, take these corrective steps. Problem Cause Acton Turn off the water supplies. Remove the handle (#3) and trim cap If the lock nut [#5) is loose tighten it. If the lock nut {#5) is tight, remove the The lock nut (#5) has come | lock nut {#5) and cartridge Verify the loose or the O-ring on the Q-rings clean and in proper alignment on the Leaks underneath the handle | .