For Models : 6737060,6737061, 6737062 FREE FALL Single Handle Bathroom Faucet Tools Adjustable Wrench (2) Teflon Tape « Groove Jolt Puller « Phillips Screwdriver « Silicone Sealant Maintenance Your new faucet Is designed for years of trouble-free performance. Keep it looking new by cleaning it periodically with a soft, damp cloth. Av old abrasive cleaners, steel wool and harsh chemicals as these will dull the finish and void your warranty.
Parts Diagram / List No.
Preparation/Assembly . Shut off the water supplies before installation. Remove the current faucet, clean and dry the sink surface the new faucet will be installed on. . Unscrew the lock nut (#22) and gasket assembly Please Note:Do not remove the customer service tag with the model number and phone number as this will be helpful if you need assistance in the future. =2 . Apply Teflon tape on threads of the faucet cold & hot water supply tubes in a clockwise direction. .
Installation Instructions 5. Slip 1/2” coupling nuts onto water supply tubes or use flexible stainless steel supply lines (recommended) — both are sold separately. To @% avoid breaking the copper tube on the faucet, 84 use two wrenches (as shown) to keep from twisting the supply tube from the faucet when you tighten the nut. Typically the cold water supply is on the s right and the hot water supply is on the left. Water Supply Hoses 6.
Installation Instructions 10. Install washer (#33) and wearing ring (#34) to 11. 12. Open the hot and cold water shutoffs. Check for 13. Turn on the faucet. Fill the sink to ensure there are no the stopper housing (without overflow hole) then hand tighten the lock nut but do not over tighten. See diagram for visual. 30 Position o-ring (#36) into outlet pipe attach nut (#38) onto outlet pipe and then hand tighten nut but do not over tighten. See diagram for visual.
Trouble-Shooting If you've followed the instructions carefully and your faucet still does not work properly, take these corrective steps. Problem Cause Action Leaks underneath handle. Lock nut (#7) has come loose. Tighten the lock Remove handle (#3) and cartridge (#9) to check If ceramic disk Is damaged permanently or dirty. Re-Install the cartridge (#9) or Water will not shut off completely.