Tools Needed For Models : 6736219, 6736220 6736261, 6736262 Adjustable Wrench Groove Joint Puller Q‘i\\ T RN N Phillips Screwdriver X « Silicone Sealant Teflon Tape FONDER Maintenance Double Handle Bathroom Faucet Your new faucet is designed for years of trouble-free performance. Keep it looking new by cleaning it periodically with a doff, damp cloth. Avoid abrasive cleaners, steel wool and harsh chemicals as these will dull the finish and cold your warranty.
Parts Diagram / List 022 27—W 23 28— §5E© Part Name 1 Spout 2 Aerator Washer 3 Aerator Core 4 O-ring 5 Spout Base é Wearing Ring 7 O-ring 8 Q-ring 9 Handle Button 10 | Screw 1 Handle 12 | Handle Connector 13 Lock Nut 14 | Cartridge {Hot) 15 | Washer 16 Wearing Ring 17 Cartridge (Cold) 18 | Deck Plate 19 | Gasket 20 Under body 21 Lack Nut 22 | Knob 23 Lift Rod 24 | Sealer 25 Rod Strap 26 Pop Up Assembly 27 | Stopper 28 | Threaded End 29 | Washer 30 | Washer & Lock Nut 31 Pop-up Body 32 Ball Rod 33 Ball Nut 3
Preparation/Assembly 1. Shut off the water supplies before installation. Remove the current faucet. Clean and dry the surface the new faucet will be installed on. 2. Unscrew the lock nuts (#21) from the under body Note: Do not remove the customer service tag with the model number and phone number. This information will be needed when calling the customer service department. 3. Place silicone sealant beneath the gasket (#19) and insert the under body (#20) through the sink holes.
Installation Instructions 7. Apply Teflon tape onto the threads of the faucet water shut offs in a clockwise direction. Tighten the water supply hoses onto the water supply shut offs. Be sure to connect the cold water supply hose to the cold water shut off (typically on the right) and the hot water supply hose to the hot water shut off (typically on the left). 8.
Installation Instructions 13. Slide one end of the spring clip (#34) onto the ball rod Insert the ball rod (#32) through a hole on the rod strap then slide the other end of the spring clip (#34) over the ball rod See the diagram for a visual. 14. Insert the lift rod (#23) through the hole on the faucet.
Troubleshooting If you've followed the Instructions carefully and your faucet still does not work properly, take these corrective steps. Problem Cause Action The lock nut (#13) has come Remove the handle Tighten the lock Leaks underneath the handle loose. nut Replace the handle Remove the handle lock nut and cartridge (#14 or #17). Check the ceramic disk for dirt and damage. If the cartridge (#14 or #17) is dirty, soak it in warm white vinegar for 4 hours, The water wil not shut off completely.