Tools Adjustable Wrench « Teflon Tape %\ Groove Jolt Puller \Q\} Sy » Silicone Sealant = Maintenance Your new faucet Is designed for years of trouble-free performance. Keep It looking new by cleaning It periodically with a soft cloth. Av old abrasive cleaners, steel wool and harsh chemicals as these will dull the finish and void your warranty. Safety Tips = If you use soldering for the Installation of the faucet, the seats, cartridges and washers will have to be removed before using flame.
Parts Diagram / List Part Name 1 Spray Head 2 Sleeve 3 Hose 4 Body 5 Quick Connect Ring é Wearing Ring 7 O-ring 8 Fixation Ring 9 Connector 10 Protective Sleeve 11 Wearing Ring 12 Button 13 Set Screw 14 Handles 15 Connector 16 Lock Nut 17 Ring 18 Wearing Ring 19 Deck Plate 20 Hot Cartridge 21 Cold Cartridge 22 Waterway 23 Gasket 24 Lock Nuts 25 O-ring 26 Tube 27 Check Valve 28 Quick Connect Assembly 29 Allen Wrench 30 Weight Have a question? DON'T GO BACK TO THE STORE, WE CAN HELP.
Preparation/Assembly 1. Shut off the water supplies before installation. Remove the current faucet, clean and dry the sink surface the new faucet will be installed on. 2. Unscrew lock nuts (#24) from underneath. Please Note —Do not remove the Customer Service Tag with model number and phone number as this will be helpful if you need assistance in the future. 24 3. Place silicone sealant beneath the gasket (#23) and install faucet shanks through the hole. See diagram for visual. 4.
Installation Instructions 5. Apply Teflon tape into threads of the water inlet ports of the faucet in a clockwise direction. o 6. Attach spray hose (#3) to the hose quick connect assembly (#28) on the faucet. Be sure to fully insert the spray hose, you will hear a light click or popping sound when connected see diagram for visual. 7. Attach the weight (#30) to the lowest point on the downward side of the hose (#3) to prevent the hose (#3) from twisting.
Installation Instructions 8. Slip 1/2” coupling nuts onto water supply tubes or use flexible stainless steel supply lines (recommended) both are sold separately. Screw these onto the inlet shanks on the bottom of the faucet. Typically the cold water supply is on the right and the hot water supply is on the left. 9. Apply Teflon tape onto the threads of the faucet water shut offs in a clockwise direction. Tighten the water supply hoses onto the water supply shut offs.
Trouble-Shooting If you've followed the instructions carefully and your faucet still does not work properly, take these corrective steps. Problem Cause Action Lock nut (#16] or cap has Tighten the lock nut (#16) or cop . Leaks underneath handier come loose. Remove handle (#14) and cortege 10 check if ceramic disk Water will not shut off completely. | Dirty of damaged cartridge Is darn aged permanently or dirty.
