Tools + Adjustable Wrench(2) Teflon T 3 © felon Tape Groove Joint Slier No \g + Phillips Screwdriver Silicone Sealant Maintenance Your new faucet is designed for years of trouble-free performance. Keep It looking new by cleaning It periodically with a soft cloth. Av old abrasive cleaners, steel wool and harsh chemicals as these will dull the finish and cold your warranty.
Parts Diagram / List 15—e 16—s o—44 —33 453— Part Name 1 Spout 2 Washer 3 | Aerator 4 Wearing Ring 5 Retainer 6 O-ring 7 Retainer 8 Flow Re stricter ? Flow Re stricter 10 | Diverted Nut 11 | Diverted 12 | Body 13 | Set Screw 14 Button 15 | Handle Button 16 | Set Screw 17 | Handle 18 | Trim Cap 19 | Lock Nut 20 | Cartridge 21 | Base 22 | Screw 23 | O-ring 24 | Threaded Shank 25 | Gasket Assembly 26 | Lock Nut 27 | Screw 28 | O-ring 29 | Copper Tube (Hot) 30 | Copper Tube (Cold) 3 Outlet Tube 32 | Quick Conne
Preparation/Assembly 1. . For Deck Plate Installation Place silicone sealant . For Single Hole Installation Place silicone sealant Shut off water supply before installation. Remove current faucet, clean and dry the sink surface the new faucet will be installed on. Unscrew the lock nut (#26) and gasket assembly Note: Do not remove the customer service tag with the model number and phone umber as this will be helpful if you need assistance in 2% the future.
Installation Instructions 7. Attach gasket assembly (#25) and lock nut (#26) 8. Without Side Spray Installation-Remove the from the bottom. Note: Assembly in numerical order. Tighten but do not over tighten. Use a fillips screwdriver ¥ to tighten the 3-screws (#27) on the lock nut 25 See diagram for visual. La —+ quick connect assembly and tighten the brass end cap 9. With Side Spray Installation-Unscrew the lock T= nut washer (#41) and spacer | i Place silicone sealant beneath the side spray fe — 10.
Installation Instructions 11. S8lip 1/2" coupling nuts onto water supply tubes or use flexible stainless steel supply lines (recommended) — both are sold separately. To avoid breaking the copper tube on the faucet, use two wrenches (as shown) to keep from twisting the supply tube from the faucet when you tighten the nut. Typically the cold water supply is on the right and the hot water supply is on the left. Water Supply Hoses 12.
Troubleshooting If you've followed the Instructions carefully and your faucet still does not work properly, take these corrective steps. Problem Cause Action Leeks underneath handle. Lock has come loose. Tighten the lock Remove the handle (#17) and cartridge (#20) to check the ceramic disk for dirt and damage. Verify the rubber o-ring is seated properly in the cartridge If not reposition the o-ring. Reinstall or replace the cartridge Water will not shut off completely.
