Tools Needed, But Not Included . Adjustable Wrench(2) Teflon Tape Ja. Groove Jo lint Puller Phillips Screwdriver Silicone Sealant Maintenance Your new faucet is designed for years of trouble-free performance. Keep it looking new by cleaning it periodically with a soft, damp cloth. Avoid abrasive cleaners, steel wool and harsh chemicals as these will dull the finish and void your warranty.
Parts Diagram / List No.
Preparation/Assembly . Shut off the water supplies before installation. Remove the current faucet. Clean and dry the surface the new faucet will be installed on. . Unscrew the lock nut (#34) and remove the gasket assembly Note: Do not remove the customer service tag with the model number and phone number. This information will be needed when calling the customer service department. . Apply Teflon tape on the threads of the faucet cold & hot water supply tubes in a clockwise direction. the gasket.
Installation Instructions . Slip 2" coupling nuts onto the water supply tubes or use flexible stainless steel supply lines (recommended) both are sold separately. Use two wrenches (as shown) to keep from twisting the supply tube off of the faucet when tightening the nut. Water Supply Hoses . Apply Teflon tape onto the threads of the faucet water shut offs in a clockwise direction. Tighten the water supply hoses onto the water supply shut offs.
Installation Instructions Remove the pump nozzle and pump (#43) from soap dispenser assembly. Unscrew the bottle lock nut (#47) and large washer Verify the small washer (#45) is in the soap dispenser base Apply silicone sealant to the bottom of the soap dispenser base (#44) and place into the far right hole. From underneath, slide the large washer (#46) onto the threads and screw on the lock nut (#47) hand tight.
Troubleshooting If you've followed the Instructions carefully and your faucet still does not work properly, take these corrective steps. Problem Cause Action Remove the handle (#3} and firm cap Leaks underneath the handle Lock nut (#5) has come loose. | Tighten the lock nut Replace the trim cap {#4) and handle Remove the handle trim cap and cartridge Check the ceramic disk for dirt and damage. If the cartridge is dirty, soak it in warm white vinegar for 4 hours.
