Technical Specifications

Installation Instructions

1. Shut off the water at the supply valves under the sink or at the main water supply.

Disconnect the supply lines. Remove the existing faucet from the sink. Clean and dry

the surface area where the new faucet will be mounted.

2. For installation with a deckplate, apply a thin bead of silicone to the underside of the

putty plate (C). Place the putty plate (C) and deckplate (B) over the mounting holes

in the sink, aligning the center hole in the putty plate (C) and deckplate (B) with the

center mounting hole in the sink (2.1).

For installation without the deckplate, skip to Step 4.

2.1

3. The deckplate (B) and putty plate (C) cannot be installed with the ange (3.1) on the

bottom of the faucet body (A). Carefully insert the water supply connectors (3.2) on

the faucet body (A) through the hole in the deckplate (B), putty plate (C), and the

mounting hole in the sink (3.3) until the faucet sits on top of the deckplate (B).

Skip to Step 5.

3.1

3.2

3.3

4. To continue installation with the optional deckplate, skip to step 5

Before installation, make sure the ange (4.3) is on the bottom of the faucet body (A)

with the rubber o-ring facing down. Carefully insert the water supply connectors (4.2)

on the faucet body (A) through the mounting hole in the sink (4.1) until the faucet (A)

sits on top of the ange (4.3).

4.3

4.2

4.1

5. From underneath the sink, secure the faucet body (A) to the sink using the rubber

washer (D), metal washer (E), and mounting nut (F). Secure the mounting nut (F) with

the screws (G).

NOTE: It is helpful to have a second person hold the faucet in place while tightening

the screws on the mounting nut.