Technical Specifications

Installation Instructions (Continued)

6. Slightly move the water supply connectors (6.1) away from the quick-connect

sprayer outlet (6.2). Be careful not to kink the copper tubes. Remove the protective

cap (6.3) from the quick-connect sprayer outlet (6.2). Push the end of the quick-

connect sprayer hose (6.4) with the quick-connect coupling (6.5) onto the quick-

connect sprayer outlet (6.2). Give the sprayer hose (6.4) a gentle tug to ensure it is

connected at both ends.

6.2

6.4

6.1

6.5

6.3

7. Remove the screws from each side of the weight (H) so it releases into two pieces.

Attach the weight (H) to the sprayer hose (7.2) at the location marked with a label on

the sprayer hose (7.2) and tighten the screws.

7.2

8. Attach one end of each of the water supply lines to the water supply connectors

(8.1) and hand tighten. The water supply connectors are labeled hot and cold. NOTE:

When installing new water supply lines, please refer to the supply line manufacturer’s

installation instructions.

8.1

9. Tighten the supply line connections using two wrenches. Place the rst wrench on

the tting on the water supply connector (9.1) to hold it in place while tightening the

supply line with the second wrench. This will help prevent twisting of the tubing. Do

not overtighten. Repeat for the second water supply connector (9.1). Use caution

when tightening the connections, as copper lines can crimp or break, causing a leak.

9.1

10. Attach one end of each of the water supply lines to the water supply valves (10.1)

and hand tighten. The water supply connectors are labeled hot and cold. NOTE:

When installing new water supply lines, please refer to the supply line manufacturer’s

installation instructions.

10.1