Technical Specifications

5.
Installation Instructions (Continued)
11. Once the installation is complete, remove the hand sprayer (11.1) from the sprayer
hose (11.2) on the faucet body (A) to ush the water lines. Turn on the water supply
and allow both hot and cold water to run for at least one minute to ush away any
debris that could cause damage to internal parts. While the water is running, check
for leaks. If a leak occurs, gently tighten the nut on the connection that is leaking.
Turn off the water and screw the hand sprayer (11.1) back onto the sprayer hose
(11.2) of the faucet body (A).
A
11.1
11.2
Care and Cleaning
Clean periodically with a soft cloth. Avoid abrasive cleaners, steel wool, and harsh chemicals, as these will dull the nish
and void your warranty.
Troubleshooting
If a faucet installation doesn’t deliver water properly or leaks, nding the cause and xing it can be easy.
PROBLEM POSSIBLE CAUSE SOLUTION
Faucet leaks underneath
handle.
Bonnet has come loose, or the
ceramic cartridge seal is dirty or
out of place.
1. Move the handle to the OFF position. Unscrew the handle screw
and remove the handle.
2. Tighten the bonnet. Move the cartridge stem to the ON position.
The leak should stop draining from around the cartridge body.
3. If the leak does not stop, shut off the water supply. Remove the
bonnet. Lift out the ceramic cartridge. Inspect the seal on the
bottom of the ceramic cartridge. Remove any debris from the seal.
If the ceramic cartridge seal is twisted or out of place, re-seat it. If
the ceramic cartridge seal is worn or damaged, replace the ceramic
cartridge by calling customer service.
4. Position the new ceramic cartridge into the faucet body.
5. Tightly screw the bonnet into the faucet body.
6. Reinstall the handle.
Water does not
completely shut off.
Ceramic cartridge discs are
worn or have debris trapped
inside.
1. Shut off the water supply.
2. Move the handle to the OFF position. Unscrew the handle screw
and remove the handle
3. Remove the bonnet. Lift out the ceramic cartridge.
4. Position the new ceramic cartridge into the faucet body.
5. Tightly screw the bonnet into the faucet body.
6. Reinstall the handle.
Faucet leaks around
aerator.
The aerator is incorrectly tted,
dirty, or small parts inside the
aerator are improperly installed.
1. Remove the aerator cover from the hand sprayer and remove the
aerator and gasket. Inspect the black rubber gasket inside the
aerator. The rubber gasket should be at.
2. Reinstall the gasket and aerator, then replace and tighten the
aerator cover on the hand sprayer.
Faucet has an improper
water pattern.
The aerator is dirty or small
parts inside the aerator are
improperly installed.
1. Remove the aerator cover from the hand sprayer and remove the
aerator and gasket.
2. Gently ush the small parts inside the aerator to clear away any
debris.
3. Reinstall the gasket and aerator, then replace and tighten the
aerator cover on the hand sprayer. Ensure all parts are straight and
at.
11