Tools Adjustable Wrench . « Teflon Tape g + Groove Jolt Puller N « Phillips Screwdriver « Silicone Sealant ' . Maintenance Your new faucet Is designed for years of trouble-free performance. Keep It looking new by cleaning It periodically with a doff cloth. Avoid abrasive cleaners, steel wool and harsh chemicals as these will dull the finish and cold your warranty.
Parts Diagram / List No. Part Name 1 Aerator 2 Connector 5 3 O-ring 4 4 Sloven _& 5 Spout 3 — 6 O-ring 7 Spout Base 2 fl 8 Retainer 9 O-ring VT 10 Diverted Connector 11 O-ring 7 12 Handle 13 Set Screws 14 Handle Button 15 Nut 8 16 | O-ring 17 Deck Plate 18 Screws 19 1/4 Ceramic Cartridge {Hot) 20 1/4 Ceramic Cartridge {Cold) 21 Body 22 Gasket 23 Washer 24 Lock Nut 25 Allen Wrench 26 Aerator wrench Have a question? DON'T GO BACK TO THE STORE, WE CAN HELP. just call 1-800-626-3525 ,8 a.m. to 5 p.m.
Preparation/Assembly 1. Shut off water supplies before installation. Remove current faucet, clean and dry the sink surface the new faucet is installed on. 2. Unscrew lock nuts {#24) and washer (#23) from underneath. Please Note Do not remove the Customer Service Tag with the model number and phone number as this will be helpful if you need assistance in the future. 3. Place silicone sealant beneath the gasket (#22) and install faucet shanks through the hole. See diagram for visual. 4.
Installation Instructions 5. Apply Teflon tape onto threads of the water inlet pores of the faucet in a clockwise direction. 6. Slip 1/2” coupling nuts onto water supply tubes or use flexible stainless steel supply lines (recommended) both are sold separately. Screw these onto the inlet shanks on the bottom of the faucet. Typically the cold water supply is on the right and the hot water supply is on the left. 7. Apply Teflon tape onto the threads of the faucet water shut offs in a clockwise direction.
Installation Instructions 8. After installing the faucet, before turning the faucet on, remove aerator (#1) using the aerator wrench turn on the hot and cold water shut offs and check for leaks. if leaks occurrefertosteps éor 7. Turn on both faucet shandies for one minute fo flush the debris from the faucet. Tums off the faucet and re-install the aerator Please Note: Do not use an adjustable wrench to remove the aerator (#1) as it may cause damage. Use the aerator wrench (#26) to remove the aerator.
Trouble-Shooting If you've followed the instructions carefully and your faucet still does not work properly, take these corrective steps. Problem Cause Action Leos underneath handle | Locking nut (#15] has come loose. | Tighten the locking nut Remove handier {#12) ond cartridge {#19 or #20) to check If ceramic Water will not shut off completely. | Dirty or damaged cartridge disks damaged permanently or (#19 or #20). dirty.
