Tools Adjustable Wrench ) Teflon Tape Groove Jo Int Slier Phillips Screwdriver Silicone Sealant Maintenance Your new faucet Is designed for years of trouble-free performance. Keep It looking new by cleaning It periodically with a soft, damp cloth. Av old abrasive cleaners, steel wool and harsh chemicals as these well dull the finish and cold your warranty. Safety Tips If you use soldering for the installation of the faucet, the seats, cartridges and washers well have to be removed before using flame.
Parts Diagram / List 16 B4 &8s o—17 No.
Preparation/Assembly 1. Shut off water supply before installation. Remove current faucet, clean and dry the sink surface the new faucet will be installed on. 2. Unscrew lock nuts (#12) and washers (#11) from underneath. Please Note: Do not remove the customer service tag with the model number and phone number as this will be helpful if you need assistance in the future. 3. Without Side Spray Installation-Remove the quick connect assembly and tighten the brass end cap 4.
Installation Instructions 6. Place silicone sealant beneath the gasket (#10) and install faucet shanks through faucet holes. See diagram for visual. 7. Hand tighten lock nut mounting body, then tighten but do not over tighten. Please Note: Do not remove the customer service tag with the model number and phone number as this will be helpful if you need assistance in the future. 8. Apply Teflon tape onto threads of the water inlet pores of the faucet in a clockwise direction.
Installation Instructions 9. 10. 11 Slip 1/2" coupling nuts onto water supply tubes or use flexible stainless steel supply lines (recommended) —both are sold separately. Screw these onto the inlet shanks on the bottom of the faucet. Typically the cold water supply is on the right and the hot water supply is on the left. Apply Teflon tape onto the threads of the faucet water shut offs in a clockwise direction. Tighten the water supply hoses onto the water supply shut offs.
Trouble-Shooting If you've followed the instructions carefully and your faucet still does not work properly, take these convective steps. Problem Cause Action Teaks underneath handle, Lock nut {#4) has come [jocose, Tighten the lock Remove handle (#3) and cartridges) [#5 or #24) 1o check f ceramic disk s damaged permanently or dirty. Re-Install the cartridge [(#5 or #24) or replace the cartridge. Dirty or damaged cartridge (#5 Water will not shut off completely.
