Parts Diagram / List Mo, Part Name 1 Lock Nut Z Washer 3| Musket 4 Body 5 .. Deck Plate & /4 Ceramic Carl ridge (Hot} 7 Red Rubber Ring 8 Lock Nul 2. l Handle 10| Burton 11 i Set Screw 12 I Aerator 12 | Blue Rubber Ring 14 1 1/4 Ceramic Cartridge (Cold) 15 | Spot 16 | Friction ring 17 | Spout Base 18 | O-Ring 12 1 O=Ring 20 | Friction ting 21 ¢ Diver fer corrector 22. | O-Ring 23.
Preparation/Assembly . Shut off water supplies before Installation. Remove current faucet, clean and dry the surface the new faucet will be installed on. . Unscrew lock nuts (#1) and washers [#2) from underneath. Note: Do not remove the customer service tag with the model number and phone number as this will be helpful if you need assistance in the future, . Place silicone sealant beneath the gasket (#3) and install faucet shanks through faucet holes. See diagram for visual. .
Installation Instructions 6. Slide the spray hose (#32) through the hole. 7. Attach the spray hose (#32) to the hose quick connect assembly (#26) on the faucet. Be sure RN to fully insert the spray hose You will hear light [/ \\ click or popping sound when connected. See diagram for visual. 8. Apply Teflon tape to threads of the water inlet ports of the faucet clockwise direction. Have a question? DON'T GO BACK TO THE STORE, WE CAN HELP, maladjusted 1-800-626-3525,8 a.m. 1o § p.m.
Pop-up Installation 2. Slip 1/2” coupling nuts-onto water supply tubes rouse flexible stainless steel supply lines (recommended] -both are sold separately. Screw these onto the inlet shanks on the bosom of the faucet. Typically the cold water supply isotherm right and the hot water supply is on the left. Ca old 10. .Apply Teflon tape monotheist threads of the faucet water shut offs in a clockwise direction. Tighten the water supply hoses onto the water supply shut-offs.
Trouble-Shooting If you've followed the Instructions carefully and your faucet still does not work properly, take these corrective steps. Problem Cause Acton Leaks underneath handier Lock nut (#8) has come [use. Tighten the lock nut Remove the handle {#9) and cartridge {#¢é or #14) to check the ceramic disk " . . for dirt and damage. Verify the rubber Water will not shut off completely. | Dirty or damaged cartridge erring is seated properly in the (#60r #14). cartridge {#6 or #14).
