Installation Instructions

ManualsBrandsTuscany ManualsBathEsa™ Two-Handle 5-Spray Polished Chrome Roman Bathtub Faucet with Handheld Shower

Table Of Contents

Summary of content (8 pages)

PAGE 1
Tools Needed, But Not Included Adjustable Wrench ~ « Groove Joint Slier W. an Phillips Screwdriver N hN Silicone Sealant WB ~ +» Knife a. » Teflon Tape Included of or ESA Maintenance Widespread Double Handle Roman Tub Your new faucet is designed for years of trouble-free Faucet with Handheld Shower head performance. Keep it looking new by cleaning it periodically with a soft, damp cloth. Avoid abrasive cleaners, steel wool and harsh chemicals as these will dull the finish and cold your warranty.
PAGE 2
Parts Diagram / List No.
PAGE 3
Preparation/Assembly 1. Shut off the water supplies before installation. Remove the current faucet. Clean and dry the surface the new faucet will be installed on. 2. Remove tee clip (#39) to take apart the tee Unscrew the lock nut (#32) and remove the gasket assembly (#58) from the diverted tube Note: Do not remove the customer service tag with the 58. model number and phone number. This information will w—s =} be needed when calling the customer service department. 3.
PAGE 4
Installation Instructions 15 6. Remove the handle button (#1) and set screw Jf Remove the handle base (#6) and handle (#15) from ra the valve body = 7. From underneath the mounting surface, Insert the 8 Ensure the O-ring (#9) Is In place In the handle base Apply silicone sealant beneath the handle base (#6) and tighten onto the valve body (#14) from above the . mounting area.
PAGE 5
Installation Instructions Handheld Shower head Installation: Verify the check valve (#41) Is In position Inside the shower hose Slide the shower hose (#55) through the hole. Screw the shower hose (#55) onto the tee Hand tighten, then use an adjustable wrench to tighten. Do NOT over tighten. Note: To install without the handheld shower head (#43) skip steps 2 and 10. Apply Teflon tape (#51) to the threads of the valve body (#14) in a clockwise direction.
PAGE 6
Installation Instructions 14. Turn on the hot and cold water and let it run for one minute. This will help clear any debris that may have come loose during installation and prevent the system from becoming clogged. Turn the water off. Stick the shower hose (#55) into the tub or a bucket to prevent spraying water out of the tub. Turn on the water, pull the knob (#33) and flush the shower hose (#55) for 30 seconds to clear any remaining debris in the lines.
PAGE 7
Troubleshooting If you've followed the Instructions carefully and your faucet still does not work properly, take these corrective steps. Problem Cause Acton Leaks underneath the handle The cartridge (#5 or #42} has come loose. Turn off the water supplies.
PAGE 8
Lifetime Limited Warranty The manufacturer warrants that the parts and assemblies of this product will be free from defects in material and workmanship under normal household use for as long as it is owned by the original consumer purchaser. This warranty covers the original purchaser with original receipt only and does not include business, commercial or industrial use of this product. This warranty shall not apply to goods which have been subject to accidents, negligence or improper installation.