Tools . Adjustable Wrench(2) « Teflon Tape Groove Jo lint Puller « Phillips Screwdriver Silicone Sealant Maintenance Your new faucet is designed for years of trouble-free performance. Keep it looking new by cleaning it periodically with a doff, damp cloth. Avoid abrasive cleaners, steel wool and harsh chemicals as these will dull the finish and cold your warranty.
Parts Diagram / List 26 2716 Part Name 1 Shower Arm Flange 2 | Shower Arm 3 | Shower Head 4 | Screw 5 Plaster Guard 6 | Trim cap 7 Lock Nut 8 [ Cartridge 9 | Cartridge Housing 10 | Valve Body 11_| Sealing Washer 12 | Stop Valve Core 13 | Stop Valve Spring 14 | Adjuster Seat 15 | Handle 16 | Screw 17 | Screw 18 | Handle Rod 19 | O-ring 20 | Handle Bar {Ceramic) 21 | Handle Cap 22 | O-ring 23 | Washer 24 | Escutcheon Gasket 25 | Escutcheon 26 | Handle Button 27 | O-ring 28 | Screw 29 | Allen Wrench 30 | Allen
Preparation/Assembly 1. Note the minimum/maximum installation dimensions Sep 1-4 Have a question? DON'T GO BACK TO THE STORE, WE CAN HELP, between the shower arm handle assembly and spout Also note, if this is a thin wall mounting, the hole for the valve body (#10) must be a7 mommy 2.2 T189mm) [twosome-sernmy Recommended 74" (1880mym) Mn Mum o! gardener | 126mm) From Floor To Roadshow, Or Grater A Doritos! Stemmed) 1 Lane: To arm 121480 ( .
Installation Instructions 5. Turn on the hot and cold water shut offs and check for leaks. If leaks occur, refer to steps 3 or 4. Turn on the faucet and let the water run for one minute. This will help clear any debris that may have come loose during installation and prevent the system from becoming clogged. Turn off the water. Note: Turn on both the hot and cold water shut offs before turning the faucet on. Not turning on both will cause your cartridge to become pressure locked.
Installation Instructions 9. Temperature Limiting Device: Remove the lock nut By default, the temperature limiting device is set to the highest temperature setting (A). In order to reduce the temperature, remove the temperature limiting device (the red cap) and turn the device clockwise to the desired temperature (position B or C).
Troubleshooting If you've followed the Instructions carefully and your faucet still does not work properly, take these corrective steps. Problem Cause Acton Leaks underneath the handle assembly The lock nut (#7} has come loose or the O-ring on the cartridge (#8) is dirty or misaligned. Turn off the water supplies. Remove the handle assembly {#49) and trim cap If the lock nut {#7) is loose tighten it.
