Tools . Adjustable Wrench(2) S « Teflon Tape : S Groove Jolt Puller \,}x =y « Phillips Screwdriver Silicone Sealant For Models : 6737068 Audrey Widespread Double Handle Bathroom Faucet Maintenance Your new faucet is designed for years of trouble-free performance. Keep it looking new by cleaning it periodically with a soft, damp cloth. Avoid abrasive cleaners, steel wool and harsh chemicals as these will dull the finish and cold your warranty.
Parts Diagram / List | 2116 2223 24 25 No.
Preparation/Assembly 1. Note the minimum/maximum installation dimensions between the shower arm handle and spout Also note, if this is a thin wall mounting, the hole for the valve body 5 (#10) must be in diameter. Zane é § this is not a thin wall mounting, the plaster guard (#5) may be removed from the valve body Note: Secure the valve body (#10) to the support cross board for stability. 3. Apply Teflon tape to all pipe threads. Install an elbow at one end of the pipe.
5. Turn on the hot and cold water shut offs and check for Installation Instructions leaks. If leaks occur, refer to steps 3 or 4. Turn on the faucet and let the water run for one minute. This will help clear any debris that may have come loose during installation and prevent the system from becoming clogged. Turn off the water. Note: Turn on both the hot and cold water shut offs before turning the faucet on. Not turning on both will cause your cartridge to become pressure locked.
Installation Instructions 9. Temperature Limiting Device: Remove the lock nut By default, the temperature limiting device is set to the highest temperature setting (A). In order to reduce the temperature, remove the temperature limiting device (the red cap) and turn the device clockwise to the desired temperature (position B or C).
Troubleshooting If you've followed the Instructions carefully and your faucet still does not work properly, take these corrective steps. Problem Cause Acton Turn off the water supplies. Remove the handle (#17) and trim cap If the lock nut [#7] is loose tighten it. If the lock nut is The lock nut (#7) has come | tight, remove the lock nut (#7) and cartridge Verify the the loose or the O-ring on the Q-ring is clean and in proper alignment on the cartridge If .
