Installation Instructions

ManualsBrandsTuscany ManualsApron-Front Kitchen SinksFarmhouse/Apron Front 36" Stainless Steel Single Bowl Kitchen Sink

Under-MountApronFront

FarmSinkInstallation

Instructions

Position the template on countertop. Locate the template front to rear, so that the sink

does not interfere with the cabinet.

Trace a line around the template. Cut along the inside of this line to create the

opening. The opening will provide a 1/8" overhang of the countertop.

Please follow all local plumbing and building codes.

The warranty will be voided if these installation instructions are not followed.

Inspect the drain and supply lines; replace if necessary.

CAUTION: Risk of personal injury. Metal surfaces are sharp and cause severe cuts.

Please use gloves and handle sink with care.

BEFORE INSTALLING THE SINK, INSPECT IT FOR DAMAGE. DO NOT INSTALL

A DAMAGED UNIT.

Disclaimer: This application must use a modified sink base and solid

surface countertop material.

FOR EXPERIENCED AND PROFESSIONAL INSTALLATION ONLY

Position bowl so that reveal is equidistant.

Then on underside of countertop, drill holes

for brass inserts of undermount clips.

Use a drill bit with stop block to avoid driling

through the top. For 1/2'' countertop material,

drill 3/8'' deep holes. Use three clips on the long

sides of the sink, and two clips on the short of the

sink, or follow the locations on the template that

comes with the sink. Drill the holes 1'' back from

the cut-out edge.

Step 3

Summary of content (4 pages)

PAGE 1
Under-Mount Apron Front Farm Sink Installation Instructions FOR EXPERIENCED AND PROFESSIONAL INSTALLATION ONLY Disclaimer: This application must use a modified sink base and solid surface countertop material. BEFORE INSTALLING THE SINK, INSPECT IT FOR DAMAGE. DO NOT INSTALL A DAMAGED UNIT. CAUTION: Risk of personal injury. Metal surfaces are sharp and cause severe cuts. Please use gloves and handle sink with care. Inspect the drain and supply lines; replace if necessary.
PAGE 2
Under-Mount Apron Front Farm Sink Installation Instructions FOR EXPERIENCED AND PROFESSIONAL INSTALLATION ONLY Disclaimer: This application must use a modified sink base and solid surface countertop material. BEFORE INSTALLING THE SINK, INSPECT IT FOR DAMAGE. DO NOT INSTALL A DAMAGED UNIT. CAUTION: Risk of personal injury. Metal surfaces are sharp and cause severe cuts. Please use gloves and handle sink with care. Inspect the drain and supply lines; replace if necessary.
PAGE 3
The clip may be too long for some installations. If this is the case, make a brace out of wood or solid material, butt it up against the sink, and on site, screw it into the cabinet wall. Measure the thickness of the brace and the cabinet wall so the screw does not go though to the other side of the cabinet. Side Walls and Bottom of Sink: Remove stains using a cleaning product that contains mild abrasives; always wipe in grain finish. Pay careful attenbion to the directional change.
PAGE 4
The clip may be too long for some installations. If this is the case, make a brace out of wood or solid material, butt it up against the sink, and on site, screw it into the cabinet wall. Measure the thickness of the brace and the cabinet wall so the screw does not go though to the other side of the cabinet. Side Walls and Bottom of Sink: Remove stains using a cleaning product that contains mild abrasives; always wipe in grain finish. Pay careful attenbion to the directional change.