Installation Instructions

Ashland Vanity Cabinet Set
Installation Instructions
WARNINGS & CAUTIONS
CARE & MAINTENANCE
WARNING: • To maintain the beauty of the furniture finish, avoid placing the
Two people are required for safe installation. Take extra
precautionary measures to ensure a secure grip on the vanity
base and top when lifting.
CAUTION:
• The bathroom floor and wall must be finished prior to
installation of the vanity base and top.
• Do not use water that exceeds temperatures of 140°F/46°C.
• Do not place any sharp or abrasive objects on the bare surface
of the vanity top.
INSTALLATION
vanity in direct sunlight.
• Avoid exposing the vanity to extreme temperatures by installing
away from heat and air vents.
• Dust frequently with a clean, soft and dry cloth.
• Wipe away any water or liquid spills on the vanity base immediately
with a clean, soft and dry cloth.
Step 1: Place the vanity in the desired position taking into account the location of your plumbing.Then install the pins(AAx4) on
the bottom of the cabinet.
Step 2: Level your cabinet from front to back and side to side. Use level for accurate reading as improper shimming may
cause your vanity to wobble and become misaligned resulting in twisting of the cabinet.
Step 3: Remove door handles (BBx2) that are pre-installed on the back side of the doors and re-install them on the front of
the doors with their original matching screws(CCx4) using a Phillips screwdriver.
Step 4:install the shelf screws(DDx4) inside the cabinet,then put the shelf on the screws.
Step 5:Measure two correct hole positions on the wall according to the two holes on the back of the cabinet. Drill holes,
place the cabinet to the wall according to the two holes,then put wall anchors(FFx2) in and drill screws (EEx2) into wall
anchors(FFx2).
Step 6:Place the vanity top centered on the cabinet. For additional stability, use clear silicone to secure the vanity top onto
the cabinet.
Step 7: Apply silicone sealant around the top of cabinet. Place and position vanity top on cabinet and let it cure.
Align mirror by centering it to vanity and install mirror using wall anchors(HHx2) and screws(GGx2). Measure two correct hole
positions on the wall according to the two holes on the back of the mirror. Drill holes, put wall anchors(HHx2) in and drill screws
(GGx2) into wall anchors them while leaving around 1/2' of the screw length outside. Hang the mirror on the screws.
AA x 4 BB x 2 CC x 4 DD x 4
EE x 2 FF x 2 GG x 2 HH x 2
SKU 6050049,50,51
Mirror (18-7/8”W x 18-
7/8”H, x 1) For Mirror
Installation:
2” Screws (x 2)
Drywall Anchors (x 2)
Vanity Top x1
Vanity Base x1
Faucet and drain not included.
Tools required for assembly :
(A) Electric drill with #2 drill bit and Phillips drive bit
(B) screws (included)
(C) Wall anchors - if the vanity will not be screwed towall
studs (x 2, included)
(D) Silicone
(E) Level
(F) Philips Screwdriver
Estimated installation time: 2-1/2 hours
(including removal of old vanity if applicable)
OVERALL DIMENSIONS of Cabinet
with Vanity Top:
33-1/1”H x 24”W x 14-1/4''D
Due to the manufacturing process of the vanity top
material, actual dimensions may vary slightly.
Please refer to the product's spec sheet available
on MENARDS.COM