Installation Guide

11
TC-950 & TC-950-WPA
July 2017
3.3.4 The AFRL has been pre-adjusted at the factory. If it needs adjusted: Pressure: Lift up on the
pressure adjustable knob (Fig. 16-1) and turn clockwise to increase air pressure. Meanwhile, if turned
counter-clockwise, the air pressure will decrease. Oil Feed: Use a screw driver to turn the screw to
adjust flow rate (Fig. 16-2). If turned clockwise, the oil flow speed will be reduced. If turned
counter-clockwise, the oil flow will be increased.
CHAPTER 4 - DEMOUNT AND MOUNT TIRE
4.1 DEMOUNT TIRE
4.1.1 Deflate the tire completely by pulling out the valve stem and/or core. Use a special tool (Wheel
Balancer Hammer) to remove balance weights from the rim (Fig. 17).
4.1.2 Place the tire between the bead breaking blade and rubber contact pad (Fig. 18). Then step down
on the Bead Breaker Pedal (Figs. 2-10 or 3-10) to detach the rim from the tire. Repeat the same
operation on the other sections of the tire to fully detach from the rim. Place the wheel with the tire
detached from the rim on the turntable and step on the Clamp Pedal (Figs. 2-9 or 3-9) to clamp the rim.
Note: You can select either the outer clamping or inner clamping to properly clamp the wheel according
to different rim types.
Fig. 16
Fig. 17
Fig. 18