Installation Guide

12
TC-950 & TC-950-WPA
July 2017
To detach the lip smoothly, you can use the brush to spread the lubricant or thick soap liquid between
the lip and rim.
4.1.3 Position the Hexangular Shaft (Fig 2-3) to the working position to situate the demount tool to be
close to the rim of the wheel, along with using the Limit Handle knob (Fig. 3-11) to position and secure
Hex Shaft to rim. Once properly positioned, secure using the Lock Handle (Fig. 2-12).
Note: The demount tool will automatically provide a small 2mm gap to the rim (Fig. 19).
The angle of the demount tool has been calibrated according to the standard rim of 13". If handling
the extra-big or extra-small rim, you can reposition.
4.1.4 Use the included Crowbar Tire Tool to detach tire from rim as shown in Fig 20, using the Hex Shaft
as a pivot point. Once the Crowbar is positioned, then step on the Turntable Pedal (Fig. 2-8) to rotate the
turntable clockwise until the entire tire lip is completely detached from rim.
Note: If handling a tubed tire, try to avoid the damage to the tube, as the operator should keep the valve
stem 4” (10cm) from the right side of the demount tool when demounting tires.
If the demounting of the tire gets jammed, please stop the machine immediately and then lift up the
pedal to let the turntable rotate counterclockwise to remove the resistance!
4.1.5 When handling the tubed tire, Take out the tube and then move the lower lip upwards to the upper
edge of the rim and then repeat the above steps to detach the other lip.
In the process of demounting tire, you should keep your hands and the other parts of your body from
the movable parts. Any necklaces, bracelets and/or loose clothing can cause injury to personnel!
4.2 MOUNT TIRE:
Before mounting a tire, ensure to check if the tire and rim are of the same dimension!
Fig. 19
Fig. 20