Installation Guide

TC-950 & TC-950-WPA

July 2017

CHAPTER 5 - MAINTANENCE & REPAIR

Only a qualified technician can execute the maintenance on the tire changer. Before any

maintenance is performed, shut off power. Meanwhile, shut off the air supply and push the air supply

switch to the off position and completely deflate the residual air in the machine. To correctly use the

tire changer and prolong its working life, it is necessary to periodically provide maintenance and

repairs according to the instruction manual. If maintenance and/or repairs are not made, there is a

possibility the operation and reliability of the machine may be affected, along with possible injury to

operator.

Monthly Maintenance:

· Keep tire changer and working area clean.

· Clean hexangular shaft (Fig. 25). Use machine oil to lubricate shaft.

· Clean turntable, clamps and demount head. Use lithium based oil to lubricate (Fig 26).

· Check the oil level on the AFRL. If the oil level is low, add SAE-30 lubrication oil to fill line as

required (Fig 27).

· Check the oil water separator trap and drain water, as required.

· Periodically check and adjust the tension of the drive belt. Properly adjust, by adjusting the nut in A

and B to proper tension (Fig. 28).

· Check all connection parts and tighten as required.

Fig. 25

Fig. 26

Fig. 27

Fig. 28