Installation Guide

18
TC-950 & TC-950-WPA
July 2017
Fig. 30
Fig. 32
-
1
CHAPTER 6 - INSTALLATION & OPERATION - LEFT SIDE PRESS ARM
6.1 INSTALLATION - LEFT SIDE PRESS ARM
6.1.1 The Left Side Press Arm ‘assistant’ can be equipped on the tire changer which can handle a tire
with the rim diameter of 20″ to assist in the operation of demounting stiff and/or low profile tires. The Left
Side Press Arm provides assistance for single operator capability.
Before installation, the power and air supply must be shut off!
6.1.1 The left and right side of the base plate of body of the tire changer can handle a tire with a diameter
of more than 20″ all have the installation hole for the left assistant prepared. Before installation, you can
remove the side panel and take off the installation rubber plug. If there is a tool box, you should detach
the tool box and set aside.
6.1.2 Unpack the Side Press Arm package and ensure all parts & components are included according to
the packing list. After confirmation, takeout the base assembly and install using the hex socket screw and
washer (Fig. 30).
6.1.3 Position the platform of the base plate, for the base assembly into the body through base plate on
the left-back side of the body. Align the threaded holes to the reinforced holes on the body’s base and
connect using hex bolts and washers (Fig 31).
6.1.4 Install the body bracket (Fig.32-1) on the base assembly. Align holes and connect to base using the
screws that were removed. Do not fully tighten at this time.
Fig. 31