Full Product Manual

11
FP14KC-X
JAN 2023
5) Remove cable guide tabs from the underside of each end of Crossbeam, using a hex head screwdriver,
Fig. 6. Set Cable Guide Tabs & hardware aside for reassembly in the follwing steps.
Fig. 6
6) Slide the cables from the ends of power-side runway and route the cables though the crossbeams
referring to the routing diagram in Fig 7.
Fig 7
CAUTION! Ensure the Cables are not twisted during routing and routed on the correct pulleys
in Runways.
Cable Guide
Tab
(Underside)
REAR
REAR VIEW
FRONT VIEW
FRONT