Installation Guide

Fig. 10
Fig. 11
Cycle the lift up and down several times to insure all air is removed from the cylinder system.
NOW THE LIFT IS READY FOR USE.
PERFORMANCE
RAISE-LIFT
1. Read operating and safety manuals before using lift.
2. Always lift a vehicle according to the manufacturers recommended lifting points
3. Position vehicle above the platform.
4. Insert the rubber locks between the vehicle and platform(Fig 12). ( There are two size of rubber
blocks. Block 1st is 100*160*80H mm, the other is 100*160*H40 mm.) (Fig 13)
Fig 12 Fig. 13
5. Raise the lift by pressing button on power unit until support contacts underside of the vehicle.
Recheck to make sure vehicle is secure..
6. Raise vehicle to desired working height. To lock the lift, press the lowering handle to relieve the
hydraulic pressure and let the lock bar set tight in a safety position.
REV A-090413