Instruction manual

7
5.1.3 Output Modes
Per the Table in Section 2.2.
5.1.4 Output Adjustments When in DVI-D Mode:
Picture Adjust - When the Picture Adjust Menu is selected, the following adjust
parameters will appear on the OSD:
Contrast 070
Bright 130
Color 070
Reset
Exit
Use the + and – buttons to choose the desired parameter, press Menu to select and
then use + or – to increase or decrease the value. Press Menu to save the value. When
finished with all adjustments, use the + and – buttons to move to Exit and then press
Menu to actually exit the routine.
5.1.5 Menu Ranges and Defaults
The adjustment range and factory preset value as follows:
Value Range Default
Contrast
Bright
Color
0~255
0~255
0~255
047
102
064
Note: Select reset to reset all adjustment back to the factory preset value.
HV adjust- When selected, the following sub-menu appears.
H-position 184
V-position 32
Use the + and – buttons to adjust the best horizontal and vertical position of the
picture.