Instruction manual

5
4.0 CONNECTING THE HARDWARE
Please study the panel drawings below and become familiar with the signal inputs,
outputs, operational controls and the location of the power connector. Turn off the HDMI
source and the HDMI Display and connect the appropriate HDMI and audio cables, first
between the source and the 1T-VS-626 and then between the 1T-VS-626 and the
display. Plug in the provided AC adapter, first to the 1T-VS-626 and then to an active
AC power source. Lastly, turn on the HDMI source and display device. (The 1T-VS-626
has no power switch and will begin to function as soon as it has the AC adapter
connected to it.)
5.0 OPERATING THE UNIT
The 1T-VS-626 is controlled via an On Screen Display (OSD) menu structure. Much of
the operation of the scaler is done automatically however there may be an occasion
where an adjustment is needed, particularly if the input signals are not presented at
standard levels. Numerous parameters can be controlled from the menu including
adjustment of video parameters, selection of output resolutions, type of audio output
and amount of audio delay.
The menu structure is shown below and is a two tier arrangement. When you press the
Menu button for the first time, you will be on the top tier. You can then use the + and –
buttons to move up and down the first tier selections until you arrive at the one
associated with the parameters you wish to adjust. (Note that some of the first tier
parameters have only one associated adjustment -- e.g. BRIGHTNESS -- whereas
others have several: e.g. FINETUNE.)
When you have reached the parameter you wish to adjust, press the Menu button again
to select that item. If there is only one item in the second tier associated with the
parameter, you can use the + and – buttons to make an adjustment. If there are more
than one item associated with the parameter, use the + and – buttons to move to the
item you wish to adjust, press the Menu button again to select that item and then use
the + and – buttons to make the adjustment.
Once the adjustment has been made, use the Menu button and + and – buttons to
navigate to where you can exit the OSD.
1T-VS-626 Front Panel 1T-VS-626 Rear Panel