Specifications

C2-1000 SERIES OPERATION MANUAL

Figure 16 Add resolution to table

Once your new resolution is added, you can program the resolution into the Scaler

using the Communications menu and then selecting Program into unit and then

selecting Program Resolutions. The application will proceed to program all the

resolutions on the list into the scaler.

Note that this will overwrite any resolutions currently in the scaler.

The second method of creating a resolution requires you to know all the detailed

timing parameters. The timings tab allows all the detailed video timing information to

be added and altered, including the title of the resolution entry (limited to 24

characters).

There are also along side the detailed timing parameters several flags that are used

to specify the signal type these are interlaced – for interlaced video signals, CCIR for

video that would normally be output on CV or YC connectors and RGB for video that

would be output on RGB or Component type connections.