Specifications

C2-1000 SERIES OPERATION MANUAL
20
RGBS (separate sync at TTL levels)
YUV/YPbPr (including tri-level).
However, please note that on some units such as Down Converters, the RGB output
is there just to loop the PC image through to the PC monitor. On Video Scalers,
bypass mode (with the unit in Standby) will feed PC/HD in to PC/HD out directly.
YUV/YPbPr (component) outputs can also be switched to RGsB (sync on green)
mode if desired - see ‘Adjust outputs’ for more information.
CV and YC outputs always function simultaneously and can be set to either standard
NTSC or PAL – see ‘Adjust outputs’ for more information. Note that
RGB/YUV/YPbPr outputs also function in this mode.
If your unit has a UTP output, this output reflects whatever is at the PC/HD/YUV
output, but is encoded to be compatible with the following UTP receivers at up to 300
meters of UTP cable.
Model Number Format Audio Max Distance
1T-CT-442 RGBHV None 150m (500')
1T-CT-444 RGBHV None 300m (1000')
1T-CT-452* RGBHV None 150m (500')
1T-CT-456* RGBHV None 300m (1000')
1T-CT-464* YPbPr*
2
None 300m (1000')
* These units are capable of also transmitting audio; however this feature is not
supported when used with a C2-1200/1250 unit.
*
2
When using a 1T-CT-464 (Serial Numbers < 223846700100x) you will need to
swap the Pb and Y connectors on the receiver to achieve a correct image.
6.3 Audio inputs and outputs
Certain models (C2-1200, C2-1250, C2-1350) support audio switching, simultaneous
with video switching. This means that audio input 1 might switch at the same time as
RGB1, audio input 2 with YC1, etc. Each audio input connector can be configured to
be ‘linked’ to a particular video input connector, so that they switch together.
Once switched, the audio input connector is linked to the audio output connector with
no audio processing or buffering taking place. The only processing that is performed,
is ‘click-less’ operation.