Specifications

C2-1000 SERIES OPERATION MANUAL
22
7 INFRA-RED REMOTE CONTROL
Your unit is compatible with an optional infra-red remote control as shown below:
Resets back to
power-on defaults
Stores current
Selects input: settings
1/2/3=RGB/CV/YC
Enables Keyer
Enables
Lock & Mix mode Fades in/out
Starts AutoSet Locks the
IR & panel buttons
(Not used.)
Selects flicker
Sets Shrink/PIP reduction level
size & position
Navigates through
Adjusts current the menu structure
menu values. & changes values.
Left/right alter
current value and Toggles between
up/down alter the zoom & pan mode
next value
Toggles freeze
Selects the next on and off
zoom level and
zoom menu Activates PIP /
Shrink mode
The transmit range of the remote control depends on many factors, but is designed
to be fairly directional. Therefore you should always aim it directly towards your unit.
The IR remote control can be disabled in the System menu. This can be used in
situations where multiple units respond to the same remote control or are located
close to one another.