Specifications

C2-1000 SERIES OPERATION MANUAL

If your unit allows ‘HDMI’ to be selected, this can also enable certain audio features

depending on the abilities of your unit.

This menu provides a simple way of capturing EDID data from an attached DVI or

HDMI monitor and storing it in one of the user-definable EDID memory data blocks

(Mem1 to Mem6) – see previous menu.

To capture a different display's EDID, perform the following:

1. Connect that display to the DVI output of the CORIO2 unit - the CORIO2 unit

will then read it automatically and store it in the ‘Mon’ EDID entry.

2. Select which EDID memory (Mem1 to Mem6) to copy this information to.

3. Select 'Grab' and click on it - this will copy the current monitor's information to

that EDID memory.

4. Change 'EDID to use' to that memory location (Mem1 to Mem6).

5. Store your unit’s settings (see earlier in this manual on how to do this).

6. Re-boot (turn off and on again) the CORIO2 unit to ensure that the graphic

card uses this new EDID data (you may need to re-boot your computer as

well).

Using the above, up to 6 custom EDID settings can be stored in the CORIO2 unit,

ready for recall later. This is useful to simulate another display being attached to a

graphic card.

8.6.3 RGB Source Menu Items

Once the Autoset sense setting has been made, this menu item is accessed and

activated. The Autoset sense utility will then correct the pixel phase and then position

the Top Left portion of the image and the Bottom Right portion of the image. Once

complete it then resume inactive status.

Since an image pixel is a very small element of the total image, it’s possible for your

unit’s Analog to Digital converters to wrongly sample the picture on the edge of each

pixel thereby losing image resolution and creating image noise. The Input pixel

phase adjustment allows you to change the position (from 0 to 31) where the pixels

are sampled, relative to the horizontal sync signal.

Source: DVI1

EDID capture [ 1] Grab

Source: RGB1

Input pixel phase [ 16]

Source: RGB1

Autoset status [Inactive]