Specifications

C2-1000 SERIES OPERATION MANUAL
43
To make this adjustment, select an RGB source and then provide an image from that
source with fine detail, preferably with very sharp vertical lines. Adjust this value
until you see the sharpest image. Alternately, adjust this value to give the worst
(noisiest/softest) image, and then add or subtract 16 to get the optimum value.
Note that the AUTOSET function (for RGB inputs only) will attempt to automatically
work out the best value for this setting.
There are several types of signals that are called RGB signals as a generic term.
Each has slightly different characteristics that set it apart from similar RGB signals –
such as how the synchronization signal is sent. This menu item lets you set the
input type to use.
Available options let you select whether the input is standard RGB or YUV (including
YPbPr signals with a tri-level sync). For some units, it also allows selection of break-
out BNC connectors to be used instead of the normal connector (signified by B- in
front of the signal type).
This menu item lets you adjust the individual RGB or YUV/YPbPr signals, in case
one component is at a different contrast to other, or if they all need to be boosted or
lowered.
8.6.4 CV & YC Source Menu Items
Of the above Source Menu items, the Autoset sense and Autoset status functions,
RGB type and Pixel phase are specific to RGB signals only. The rest of the Source
menu items function with RGB, CV or YC type signals. In addition, there are four
additional Menu items that are only used with CV or YC type signals and these are
explained below:
Adjust the Brightness and Contrast of the image to your requirement.
Saturation is the amount of color present in the image. Hue is the color “tint”
parameter and the adjustment range is +90 degrees through to -90 degrees with 0
being the default.
Source: YC1
Satur [100] Hue [0]
Source: YC1
Bright [100] Contrast [100]
Source: RGB1
RGB contr. [100] [100] [100]
Source: RGB1
RGB input type [RGBHV]