Specifications

C2-1000 SERIES OPERATION MANUAL
67
Set output 1 window B Source to RGB2
F 04 00 42 00 82 000011 D9 CR F 44 00 42 00 82 000011 19 CR
Set output 1 window A to Enable advanced aspect
control
Note checksum is ?? for debugging
F 04 00 41 01 02 000001 ?? CR F 44 00 42 01 02 000001 8A CR
Set 1A Shrink to 110 – invalid max for shrink is 100
F 04 00 41 00 87 00006E ?? CR F 44 00 41 00 87 000064 70 CR
Read 1C Zoom level – invalid as window C does not exist
F 84 00 43 00 86 - ?? CR F 04 00 43 00 86 000000 CD CR
Read 1B Zoom level Zoom = 100
F 84 00 42 00 86 - ?? CR F 44 00 42 00 86 000064 70 CR
Set baud to 9600 Reply is at 9600 baud
F 04 00 42 00 AB 000000 F0 CR F 44 00 42 00 AB 000000 30 CR
Set 1A Zoom = 300
F 04 00 42 00 86 00012C F7 CR F 44 00 42 00 86 00012C 37 CR
Set 1A Shrink to 50
F 04 00 42 00 87 000032 FE CR F 44 00 42 00 87 000032 3E CR
Set 1A Shrink H Posn to 0
F 04 00 42 00 DA 000000 1F CR F 44 00 42 00 DA 000000 5F CR
Set 1A Shrink V Posn to 100
F 04 00 42 00 DB 000064 84 CR F 44 00 42 00 DB 000064 C4 CR
10.5 Reading and writing macros
Depending on the unit connected there can be up to 7 macros stored in the unit.
These macros can be programmed to perform a specific task, for example enable
PIP mode, Position pip window at H=0, V=0, Zoom in to 120%.
The WIN and OUT bytes are not used for macro reading or writing and should be set
to WIN=1A and OUT = 0
The CHA byte indicates the macro we are programming / reading / running. Macro 1
to 5 are CHA 0..4, CHA=5 is restore, CHA 6..7 are Macros 6..7.
Macro Restore (CHA=5) is read only, the units restore state is set by sending the
Store command (0C8).