User's Manual

Trigger Snap: If selected, the system will capture images on motion detection and save the

images on an SD card (this function is only available for the models with SD slot).

Trigger SD Recording: If selected, video will be recorded on an SD card on motion

detection (this function is only available for the models with SD card slot).

Trigger Email: If “Trigger Email” and “Attach Picture” are checked (email address must be

set first in the Email configuration interface), the captured pictures and triggered event will be

sent into those addresses.

Trigger FTP: If “Trigger FTP” and “Attach Picture” are checked, the captured pictures will

be sent into FTP server address. Please refer to FTP configuration chapter for more details.

2. Set motion detection area and sensitivity. Click the “Area and Sensitivity” tab to go to the

interface as shown below.

Move the “Sensitivity” scroll bar to set the sensitivity. Higher sensitivity value means that

motion will be triggered more easily.

Select “Add” and click “Draw”. Drag the mouse to draw the motion detection area; Select

“Erase” and drag the mouse to clear motion detection area.

After that, click the “Save” to save the settings.

3. Set the schedule for motion detection. The schedule setup steps of the motion detection are

the same as the schedule recording setup (See Schedule Recording).

4.3.2 PIR Alarm

PIR alarm: Alarms will be triggered when the camera detects human bodies or animals.

1. Enable PIR alarm and then set the alarm holding time.

2. Set alarm trigger options. The setup steps are the same as motion detection. Please refer to

motion detection chapter for details.

3. Set the schedule for PIR alarm. The schedule setup steps of the PIR alarm are the same as

the schedule recording setup (See Schedule Recording).