User's Manual

2. Click “Enable” and set the alarm holding time.

3. Set alarm trigger options. Trigger alarm out, Email and FTP. The setup steps are the same

as motion detection. Please refer to motion detection chapter for details.

Note: SD card full and SD card error are only available for the models with SD slot.

 IP Address Conflict

1. Go to ConfigAlarmAnomalyIP Address Collision as shown below.

2. Click “Enable alarm” and set the alarm holding time.

3. Trigger alarm out. When the IP address of the camera is in conflict with the IP address of

other devices, the system will trigger the alarm out.

Note: This function is only available for the models with alarm output interface.

 Cable Disconnection

1. Go to ConfigAlarmAnomalyCable Disconnected as shown below.