User's Manual

2. Click “Enable” and set the alarm holding time.

3. Trigger alarm out. When the camera is disconnected, the system will trigger the alarm out.

Note: This function is only available for the models with alarm output interface.

4.3.4 Alarm In

This function is only available for some models. To set sensor alarm (alarm in):

Go to ConfigAlarmAlarm In interface as shown below.

1. Enable alarm and set the alarm type, alarm holding time and sensor name.

2. Set alarm trigger options. The setting steps are the same as motion detection. Please refer to

motion detection chapter for details.

3. Click the “Save” button to save the settings.

4. Set the schedule of the sensor alarm. The setup steps of the schedule are the same as the

schedule recording setup. (See Schedule Recording).

4.3.5 Alarm Out

Go to ConfigAlarmAlarm Out interface as shown below: