User's Manual

26
Alarm Out Mode: Alarm linkage, manual operation, day/night switch linkage and schedule
are optional.
Alarm Linkage: Having selected this mode, select alarm out name and alarm holding time at
the “Alarm Holding Time” pull down list box.
Manual Operation: Having selected this mode, click “Open” to trigger the alarm out
immediately; click “Close” to stop alarm.
Day/Night Switch Linkage: Having selected this mode, choose to open or close alarm out
when the camera switches to day mode or night mode.
Schedule: Click “Add” and drag the mouse on the timeline to set the schedule of alarm out;
click “Erase” and drag the mouse on the timeline to erase the set time schedule. After this
schedule is saved, the alarm out will be triggered in the specified time.
4.3.6 Alarm Server
Go to AlarmAlarm Server interface as shown below.
Set the server address, port, heartbeat and heartbeat interval. When an alarm occurs, the
camera will transfer the alarm event to the alarm server. If an alarm server is not needed, there
is no need to configure this section.
4.4 Event Configuration (Optional)
(Only some customized version may support the following functions).