User's Manual

30
4.4.3 Intrusion
Intrusion: Alarms will be triggered if someone or something intrudes into the pre-defined
areas. This function can be applicable to important supervision places, danger areas and
prohibited areas, like military administrative zones, house breaking, scenic high danger areas,
no man’s areas, etc.
Go to ConfigEventIntrusion interface as shown below.
1. Enable region intrusion detection alarm and set the alarm holding time.
2. Set alarm trigger options. The setup steps are the same as motion detection. Please refer to
motion detection chapter for details.
3. Click the “Save” button to save the settings.
4. Set the alarm area of the intrusion detection. Click the “Area” tab to go to the interface as
shown below.
Set the alarm area number on the right side. Up to 4 alarm areas can be set up.