User's Manual

8
Face Recognition &Access Control Terminal User Manual
 Access through static IP
Network connection
The setting steps are as follow:
① Go to ConfigNetworkPort menu to set the port number.
② Go to Config NetworkTCP/IP menu to set the IP address. Check “Use the following
IP address” and then enter the static IP address and other parameters.
③ Open the IE browser and enter its WAN IP and http port to access.
2.2 Wi-Fi Connection
① Use the network cable to connect the camera and wireless router or AP.
② Connect to the above wireless network with your PC. Then run the IP-Tool on your PC
and then find the IP address of the camera. The default IP address of this camera is
192.168.226.201. Modify the IP address and gateway of the camera and make sure its network
address is in the same local network segment as the computer’s. Then double click it. This
will bring you to the login interface of the camera. Enter the default username and password
to log in. (See 2.1.1 for details)
③ Click ConfigNetworkWIFI to go to the following interface. Enable WI-FI, select the
desired router, enter the key and select encryption type.