User's Manual

Face Recognition &Access Control Terminal User Manual

3 Face Recognition Configuration

3.1 Face Match Settings

Go to the face match configuration interface via Web Client to set the face match parameters.

1. Go to ConfigFaceFace Match Config interface.

2. Enable liveness detection. If enabled, the system can distinguish real faces from non-real

face spoof attacks.

Save Source Information: if enabled, the system will send the original picture to the

pre-defined Email/FTP server when faces are detected and “Trigger Email/FTP” is checked.

Save Face Information: if enabled, the system will send the face picture to the pre-defined

Email/FTP server when faces are detected and “Trigger Email/FTP” is checked.

3. Set alarm holding time and alarm trigger options.

Trigger Email: If “Trigger Email” and “Attach Picture” are checked (email address must be

set first in the Email configuration interface), the captured pictures and triggered event will be

sent into those addresses.

Trigger FTP: If “Trigger FTP” is checked, the captured pictures will be sent into FTP server

address. Please refer to FTP configuration chapter for more details.

4. Set face comparison options.