User's Manual

Face Recognition &Access Control Terminal User Manual

For example, supposed that the unlocking mode of someone is set to “Face Comparison and

Swiping Card”, this person shall be matched successfully and swipe the card on the device,

and then he/she can pass.

For a stranger, if you want to allow his/her access, the list type shall be set as “Stranger

(including visitor and allow list), or the door cannot be linked to open.

5.3 Door Contact Settings

Click ConfigAccess ControlDoor Contact Setting to go to the following interface.

Door Contact Input Type: NO or NC

Unlocking Delay Time: the allowable unlocking time. For example, if it is set to 10 seconds,

alarms will be triggered when the door is not closed after 10 seconds.

Alarm Delay Time: set the alarm delay time when faults of the door contact are detected. For

example, if it is set to 3s, when detecting the failure of the door contact, alarms will be

triggered 3s later.

Please select the alarm trigger options as needed. The setup steps of the alarm trigger options