User's Manual

Face Recognition &Access Control Terminal User Manual

are similar to the face match settings. Please refer to face match settings chapter for details.

5.4 Wiegand Settings

Click ConfigAccess ControlWiegand Config to go to the following interface.

Wiegand Config: Wiegand Input, Wiegand Output or Off can be selected. If the card reader is

connected to the Wiegand interface, please select “Wiegand Input”. If the access controller is

connected to the Wiegand interface, please select “Wiegand Output”.

Wiegand Mode: 26bit(8), 26bit(10), 34bit, 37bit, 42bit, 46bit, 58bit or 66bit can be

selectable.

5.5 Tampering Alarm Settings

In order to avoid the removal or damage by the external force, the tampering alarm can be set

for the terminal. Click ConfigAccess ControlTampering Alarm Setting to go to the

following interface.

Enable “Tampering Alarm” and then set the alarm holding time and alarm trigger options.

Trigger Audio Alarm: if enabled, you will hear the warning sound when the terminal is

removed or damaged by the external force.

The setup steps of other alarm trigger options are similar to the face match settings. Please

refer to face match settings chapter for details.