User's Manual

30
Face Recognition &Access Control Terminal User Manual
Video Blur Detection: Alarms will be triggered if the video becomes blurry.
Video Cast Detection: Alarms will be triggered if the video becomes obscured.
2. Set the alarm holding time.
3. Set the sensitivity of the exception detection. Drag the slider to set the sensitivity value or
directly enter the sensitivity value in the textbox. Click “Save” button to save the settings.
The sensitivity value of Scene Change Detection: The higher the value is, the more sensitive
the system responds to the amplitude of the scene change.
The sensitivity value of Video Blur Detection: The higher the value is, the more sensitive
the system responds to the blurriness of the image.
The sensitivity value of Video Cast Detection: The higher the value is, the more sensitive
the system responds to the obscuring of the image.
4. Set alarm trigger options.
Trigger Email: If “Trigger Email” and “Attach Picture” are checked (email address must be
set first in the Email configuration interface), the captured pictures and triggered event will be
sent into those addresses.
Trigger FTP: If “Trigger FTP” is checked, the captured pictures will be sent into FTP server
address. Please refer to FTP configuration chapter for more details.
5. Click “Save” button to save the settings.
6.4 Network Configuration
6.4.1 TCP/IP
Go to ConfigNetworkTCP/IP interface as shown below. There are two ways for
network connection.
Use IP address (take IPv4 for example)-There are two options for IP setup: obtain an IP
address automatically by DHCP and use the following IP address. Please choose one of the
options as needed.
Test: Test the effectiveness of the IP address by clicking this button.
Use PPPoE-Click the “PPPoE Config” tab to go to the interface as shown below. Enable