User's Manual

32
Face Recognition &Access Control Terminal User Manual
2. Choose a wireless device on the list. The SSID and security mode of the wireless device
will be shown automatically. Please don’t change it manually.
3. Enter the key to connect the wireless device. This key should be set on the wireless device
in advance for wireless network connection.
After the above-mentioned wireless network is configured, you can choose “Obtain an IP
address automatically” or “Use the following IP address”.
If you choose “Obtain an IP address automatically”, you shall get the IP address from the
router. Or you can choose “Use the following IP address” to set the network parameters
manually. Then you can use this IP address to log in mobile surveillance APP/ web
client/CMS/NVR/…
6.4.3 Port
Go to ConfigNetworkPort interface as shown below. HTTP port, Data port and RTSP
port can be set.
HTTP Port: The default HTTP port is 80. It can be changed to any port which is not
occupied.