User's Manual

29
Face Recognition &Access Control Terminal User Manual
1. Enable the applicable detection that’s desired.
Scene Change Detection: Alarms will be triggered if the scene of the monitor video has
changed.
Video Blur Detection: Alarms will be triggered if the video becomes blurry.
Video Cast Detection: Alarms will be triggered if the video becomes obscured.
2. Set the alarm holding time.
3. Set the sensitivity of the exception detection. Drag the slider to set the sensitivity value or
directly enter the sensitivity value in the textbox. Click “Save” button to save the settings.
The sensitivity value of Scene Change Detection: The higher the value is, the more sensitive
the system responds to the amplitude of the scene change.
The sensitivity value of Video Blur Detection: The higher the value is, the more sensitive
the system responds to the blurriness of the image.
The sensitivity value of Video Cast Detection: The higher the value is, the more sensitive
the system responds to the obscuring of the image.
4. Set alarm trigger options.
Alarm Out: If selected, this would trigger an external relay output that is connected to the
camera on detecting the video exception.
Trigger Email: If “Trigger Email” and “Attach Picture” are checked (email address must be
set first in the Email configuration interface), the captured pictures and triggered event will be
sent into those addresses.
Trigger FTP: If “Trigger FTP” is checked, the captured pictures will be sent into FTP server
address. Please refer to FTP configuration chapter for more details.
5. Click “Save” button to save the settings.
6.3.2 IP Address Conflict
1. Go to ConfigAlarm Exception IP Address Collision as shown below.
2. Click “Enable alarm” and set the alarm holding time.
3. Trigger alarm out. When the IP address of the camera is in conflict with the IP address of
other devices, the system will trigger the alarm out.