User's Manual

42
Face Recognition &Access Control Terminal User Manual
The setup steps are as follows:
Check the “Enable address filtering” check box.
Select “Block/Allow the following address”, IPv4/IPv6/MAC and then enter IP address or
MAC address in the address box and click the “Add” button.
6.5.4 Security Management
Go to ConfigSecuritySecurity Management as shown below.
In order to prevent against malicious password unlocking, “locking once illegal login”
function can be enabled here. If this function is enabled, login failure after trying six times
will make the login interface locked. The camera can be logged in again after a half hour or
after the camera reboots.
6.6 Maintenance Configuration
6.6.1 Backup and Restore
Go to ConfigMaintenanceBackup & Restore.