User's Manual
Table Of Contents
- Introduction
- Network Connection
- Face Recognition Configuration
- Live View
- Access Control Settings
- Other Configurations
- Search
- Face Match Result Search
- Appendix
- Appendix 1 Troubleshooting
- Appendix 2 Specifications
2
Face Recognition &Access Control Terminal User Manual
2 Network Connection
2.1 LAN
In LAN, there are two ways to access IP-Cam: 1. access through IP-Tool; 2. directly access
through IE browser.
2.1.1 Access through IP-Tool
Network connection:
① Make sure the PC and IP-Cam are connected to the local network and the IP-Tool is
installed in the PC from the supplier.
② Double click the IP-Tool icon on the desktop to run this software as shown below:
③ Modify the IP address. The default IP address of this camera is 192.168.226.201. Click the
information of the camera listed in the above table to show the network information on the
right hand. Modify the IP address and gateway of the camera and make sure its network
address is in the same local network segment as the computer’s. Please modify the IP address
of your device according to the practical situation.