Operating Manual Manual

TRANSARC 130i
INTRODUCTION 2-6 Manual 0-5283
NOTE 4
Minimum Generator Recommendation at the Maximum Output Duty Cycle.
Due to large variations in performance and specifications of different brands and types of genera
-
tors, Cigweld cannot guarantee full welding output power or duty cycle on every brand or type of
generator.
Some small generators incorporate low cost circuit breakers on their outputs. These circuit break
-
ers usually will have a small reset button, and will trip much faster than a switchboard type circuit
breaker. This may result in not being able to achieve full output or duty cycle from the power source
/ generator combination. For this reason we recommend a generator that incorporates switchboard
type circuit breakers.
Cigweld recommends that when selecting a generator, that the particular power source / generator
combination be adequately trialled to ensure the combination performs to the users expectations.
NOTE 5
CIGWELD reserves the right to change product performance and specifications without notice.
2.11 Options and Accessories
DESCRIPTION PART NUMBER
TIG Torch 17V with 4m lead and remote control W4013804
TIG Torch accessory kit BGSAK2
Foot Control with 8m lead W4015800
Electrode Holder Lead 5m 400A 25mm² DINSE TW52525EH
Work Lead 5m 400A 25mm² DINSE TW53525WL
Electrode Holder with trigger switch and 4m lead 646762
25mm² Male DINSE cable connector 705152
Naka Measurement Gauge 646265
Shielding Gas Hose Assembly, 3M W7004913
Table 2-2: Transarc 130i Options and Accessories